Conrad Electronic 751549, Operating Instructions Manual

Page: 49 / 118

8.8 Programming User Code to “OUTPUT 2” (G)
☞
To carry out this programming step the code lock should now be in
programming mode (see Chapter “8.1 Entering Programming
Mode”).
Note that the user numbers for “OUTPUT 1” (F) must be 4 digits long
and those for “OUTPUT 2” (G) must be 3 digits. The user code can
be 4-8 digit long.
User numbers cannot be assigned twice.
To programme a user code to the relay output 2 “OUTPUT 2” (G) enter the following key
combination:
51 3 digit user number 4-8 digit user code # #
Example:
51 113 9877 # #
8.9 Deleting User Code for “OUTPUT 2” (G)
a) Deleting all User Codes for “OUTPUT 2” (G)
To delete all user codes programmed to the relay output “OUTPUT 2” (G) enter the fol-
lowing key combination:
5 0000 #
b) Deleting Individual User Codes for “OUTPUT 2” (G)
To delete individual user codes programmed to the relay output “OUTPUT 2” (G) enter
the following key combination:
Example delete user code:
52 Enter the user code of "OUTPUT 2" (G) #
to be deleted
47