Conrad Electronic 751549, Operating Instructions Manual

Page: 44 / 118

8.3 Standby Mode
The normal operating mode is referred to as standby mode. The code lock is in standby
mode if it is not currently in programming mode.
During the standby mode the yellow “STATUS” LED blinks at 2 second intervals.
8.4 Programming Master Code
☞
To carry out this programming step the code lock should now be in
programming mode (see Chapter “8.1 Entering Programming
Mode”).
The Master Code factory setting is: 1234
☞
The Master Code is required to enter the programming mode. We
strongly recommend you change the Master Code when putting the
unit into operation.
The Master Code must consist of between 4 and 8 digits.
Enter the following key combination to enter a new Master Code:
0 New Master Code #
Example:
0 4321 #
42