Conrad Electronic 751549, Operating Instructions Manual

Page: 46 / 118

1 4 digit user number Now hold the ID card up to the #
“card reader” (5).
Example:
1 1112 The card to be programmed in is #
held up to the “card reader” (5)
8.5.3 Programming User Code to “OUTPUT 1” (F)
☞
To carry out this programming step the code lock should now be in
programming mode (see Chapter “8.1 Entering Programming Mode”).
To programme a user code to the relay output “OUTPUT 1” (F) enter the following key
combination:
1 4 digit user number 4-8 digit user code #
Example:
1 1112 9876 #
☞
Saving user codes
On the keypad (7) press the key “1” and now enter a 4-digit user number and a 4 to 8-dig-
it user code. Press the “number” key “#” - the green LED (4) blinks. Press the “number”
key “#” again and the green LED (4) stops blinking. Your entry is confirmed.
☞
If you want to save several codes, you do not have to press the
“number” key “#” again after the second time. Save the individual
codes as described above and press the “number” key “#” after the
last entry. This saves all previous entries as well.
Input:
“1” --- “4-digit user number” --- “4 to 8-digit user code” --- “#” --- “#”
8.5.4 Deleting ID Cards or User Codes from “OUTPUT 1” (F)
☞
To carry out this programming step the code lock should now be in
programming mode (see Chapter “8.1 Entering Programming
Mode”).
44