Condre CD Tracer, User Manual

Page: 14 / 43

Getting Started Condre CD Duplicator
10
Make Multiple Copies at Once from a Master CD (continued)
Place Blank
CDs in the
Drives 1. Place a blank CD in each of the CD writers. Note that the system starts
counting the number of active CD drives as you insert blank CDs.
Copy
Operation
Starts
Automatically Once the system has identified all of the blank CDs it automatically starts to
copy the contents from the selected partition on the hard drive to the blank
CDs. You can note the progress of the copy operation by observing the
L
and
C
status. The copy operation is complete when the number for
C
equals
the number of minutes of the CD.
When the load procedure is finished, you will hear a three-tone beep, all
seven drawers will automatically open, and the LCD panel will indicate that
the load operation passed:
Remove the
Master CD 11. Remove the duplicates from the drawers, close the drawers (using the
open/close button on the CD drive).
Congratulations! You have just made seven duplicates from the hard drive.
Note the
Initial
Operation
Mode 1. Turn on the system. Note the mode of operation in the LCD display area
(
copy, emulate
, etc.). Your LCD display should look something like
this:
Access the
Sub-Function
Menu 2. Press and hold the Mode button until you hear the system “chirp.” Then
release the Mode button. You should see
setup
displayed in the LCD
panel:
PASS 7 FAIL 0
Go>
setup
<mod
copy
<mod