Motorized Cooling Valve
If you have the optional motorized
cooling valve, connect the cooling
water supply to the female
3/
4
inch
NPT fitting on the valve. except as
noted, all other connections should
be made as described above.
The Thermolator process inlets and outlets must be connected
to the plumbing that will circulate the temperature-controlled
water or fluid through the process. Cooling water inlets and
outlets are connected to the cooling water supply.
Remove the shipping pipe plug
from the female
connections on the back of the Thermolator.
Install pipe to the rear of the Thermolator.
Use male 1
1/
4
-inch NPT piping for process connections
and male
3/
4
inch NPT piping for water connections. Pipe
and pipe threads must be clean and new. Clean threads
with solvent, removing all oil, grease and dirt. Allow the
threads to dry before proceeding.
Coat the pipe threads with thread sealant.
Follow the sealant manufacturer’s directions.
Connect the male pipe to the appropriate
female connection on the back of the unit
. Start
by hand until the threads engage, then use a pipe wrench
to tighten the connection only enough to prevent leaks.
Do not over-tighten!
C
ONNECTING
P
ROCESS AND
W
ATER
S
UPPLY
L
INES
Thermolator TW-1 and TW-2
UGH015/0100
3-4
I
NSTALLATION
1
2
3
4
Tools for installation:
❒
Pipe wrench large enough
for a 2-inch pipe
❒
Premium quality Teflon
thread sealant
NOTE:
We recommend
that you install an
external ball valve on
the cooling water inlet
of the Thermolator. This
valve is required when
the purge valve option
is installed.
From
process
To
process
From
process
To
process
Cooling water out
Cooling water out
Cooling water in
Cooling water out
Cooling water in
DIRECT INJECTION
CLOSED CIRCUIT
ISOLATED CIRCUIT
From
process
To
process
Summary of Contents for Thermolater vacuTrac
