Comtrend Corporation VR-3071 Series, User Manual

Page: 14 / 227

13
WPS Button
Press the WPS button less than 2 seconds to enable WPS which will allow 2 minutes
for WiFi connection.
DSL
Connect to the DSL port with the DSL RJ11 cable. The VR-3071 supports the
following DSL profiles -
ADSL : ADSL, ADSL 2, ADSL 2+.
VDSL : 8a, 8b, 8c, 8d, 12a, 12b, 17a, 30a and 35b.
USB Port
This port can be used to connect the router to a storage device. It can only be used
for SAMBA(storage) and for a Printer Server. Support for other devices may be
added in future firmware upgrades.
LAN (Ethernet) Ports
You can connect the router to up to four LAN devices using RJ45 cables. The ports
are auto-sensing MDI/X and either straight-through or crossover cable can be used.
ETH WAN PORT
This port is designated to be used for Ethernet WAN functionality only. Use
1000-BASE-T RJ-45 cables to connect to Gigabit WAN server, or 10/100BASE-T
RJ-45 cables for standard network usage. This ports is auto-sensing MDI/X; so
either straight-through or crossover cable can be used.
Power ON
Press the power button to the OFF position (OUT). Connect the power adapter to the
power port. Attach the power adapter to a wall outlet or other AC source. Press the
power button to the ON position (IN). If the Power LED displays as expected then
the device is ready for setup (see section – LED Indicators).
Caution 1: If the device fails to power up, or it malfunctions, first verify that the
power cords are connected securely and then power it on again. If the
problem persists, contact technical support.
Caution 2: Before servicing or disassembling this equipment, disconnect all power
cords and telephone lines from their outlets.