Diagnostics and Troubleshooting
6-9
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: g-ch6 Diagnostics and Troubleshooting Last Saved On: 3/3/99 11:54 AM
Table 6-2
Fault Symptom Codes
continued
FSC
Message
Description
2008
Illegal Move
While attempting to perform a MOVE
operation, the source or destination
locations were in the wrong state
(FULL or EMPTY).This also occurs if
the MOVE is attempted with an invalid
cartridge map.
2009
Door Open
A command was received while the
door was open.
200A
Menu Mode
A command was received while the
unit was in Menu mode.
200C
Cart Unaccessible
An attempt was made to fetch a
cartridge from a drive that is not in the
unloaded state. This only applies
when the system is configured for
explicit unloads.
200D
Drive In Error
An attempt was made to access a
drive which is in an error state.
200E
No Magazine
The element is not available because
the magazine is not installed.
200F
Removal Prevented
Medium removal was attempted when
in a Prevent Removal State.
2010
Ctl Firmware Error
An invalid configuration was detected.
The configuration jumpers on the main
board may not be set properly.
2011
Ctl Firmware Error
A status block was received by the
Control Process operating in a Stand-
Alone or Slave configuration. Since
commands are never sent in these
modes, status cannot be received.
continued
