3-24
Rack-Mount Server Installation
For use with Intel Pentium II Xeon processor-based servers only
Writer: Salvo Project: Compaq ProLiant 5500 Servers Setup and Installation Guide Comments: 328470-001\July 1998
File Name: D-CH03.DOC Last Saved On: 7/6/98 4:04 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
WARNING:
To reduce the risk of personal injury, be careful
when pressing the server rail release latches and sliding the
server into the rack. The slide rails could pinch your fingertips.
3. Press the server rail release latch on either side of the server and slide
the server into the rack.
IMPORTANT:
The first time you slide the server into the rack, you may
have to apply some pressure. After the first time, the ball bearings in the
slide will move easily.
IMPORTANT:
When servicing the server, fully extend the server until the
latches lock. To return the server to the rack, depress the latches and slide
the server into the rack.
4. Secure the server face plate to the front of the rack by screwing the
thumbscrews into the cage nuts.
5. Tighten the thumbscrews before you close the rack door to prevent the
door from hitting protruding thumbscrews.
Attaching the Cable
Management Arm
A double-hinged cable management arm and fasteners ship with each server.
The cable management arm attaches to the server's cable management arm
bracket and to the rear frame of the rack. All cables to and from the server are
tied to this arm. The two hinges allow the cable management arm with attached
cables to swing out of the way when you need to access the server pull-out
trays.
Summary of Contents for ProLiant 5500
Page 8: ......
