Connectors, Switches, Security Override Jumper and Status LED Indicators
Compaq ProLiant DL360 Generation 2 Server Maintenance and Service Guide
5-7
COMPAQ CONFIDENTIAL
Codename: Maisto Part Number: 233831-001 Last Saved On: 12/12/01 10:24 AM
Integrated Lights-Out Security Override Jumper
The iLO Security Override allows the administrator full access to the iLO processor. This
will be necessary in the event of a lost or forgotten administrator password and also to flash
the iLO boot-block. The iLO Security Override is a jumper located inside the server and
cannot be activated without removing the server access panel.
4
3
2
1
Figure 5-5: Integrated Lights-Out security override jumper (non-
override position)
Using the Integrated Lights-Out Security Override Jumper
The iLO Security Override Jumper allows emergency access to the administrator with
physical control of the server’s system board. Setting the iLO Security Override Jumper
allows login access, with all privileges, without a user ID and password.
To set the iLO Security Override Jumper:
1. Power down the server. See “Powering Down the Server” in Chapter 2.
2. Remove the server from the rack. See “Removing the Server from the rack” in Chapter 2.
3. Remove the server access panel. See “Server Access Panel” in Chapter 2.
4. Locate the three pins of J29 and move the jumper from the front and center pins to the
center and rear pins to override password security. J29 is to the front of the 30 pin
Remote Insight Connector.
5. Replace the server access panel and put the server back into the rack by reversing steps 2
and 3.
6. Press the Power/On Standby switch to power on the server.
7. Logon to the iLO and reset the passwords.
