Removal and Replacement Procedures
Compaq ProLiant DL360 Generation 2 Server Maintenance and Service Guide
2-7
COMPAQ CONFIDENTIAL
Codename: Maisto Part Number: 233831-001 Last Saved On: 12/12/01 3:47 PM
Removing the Server from the Rack
Depending on the rail option deployed on the server, perform one of the following:
•
For the standard fixed rail deployment, disconnect all the peripherals cables and loosen
the thumbscrew that holds the fixed cable tray to the server. Extend and remove the
server from the rack. Place the server on a flat level workspace.
•
For the Sliding Rails and Cable Management Solution, extend the server to its fullest
extent from the rack.
Reverse these procedures to replace the server into the rack.
Server Access Panel
To remove the access panel:
1. Press and hold down the hood latches
.
2. Holding the latches down, slide the access panel towards the rear of the server about
0.5 inch (1.25 cm) and lift the panel to remove it
.
The server is now ready for servicing.
1
2
1
Figure 2-3: Removing the access panel
Reverse steps 1 through 2 to replace the access panel.