57
Select the ports to join the trunk group. The system allows a maximum of four ports
to be aggregated in a trunk group. Click
and the ports focused in the
right side will be shifted to the left side. To remove unwanted ports, select the ports
and click
.
When LACP enabled, you can configure LACP Active/Passive status for each port
on the
State Activity
tab.
Click
.
Use
to delete Trunk Group. Select the Group ID and click
.
Port Trunk—Aggregator Setting interface (four ports are added to the left field with LACP enabled)
Summary of Contents for CNGE2FE24MS
