34
IE-MLG-M1200E-01
Applications notes
Recommended settings for the portable application
______
In this application, the Multilogger is powered from batteries and a fast
response time and an easy battery recharge after the measurement
are required. Recorded data are downloaded after measurement.
We recommend to use the Multilogger with NiMH accumulators;
specify the following device configuration:
NiMH accumulators (if they are installed).
Do not turn on the
Energy saving mode.
The Multilogger will perform
measurement with a fast sampling (1 second).
Switch off the display backlight or allow it only upon pressing a key.
Active backlight drastically reduces the battery life. However, even
when it is permanently on, the Multilogger with fully charged
batteries will operate about one week with the lowest backlight
intensity (25%).
Switch off the optical alarm signalization using the LED diodes or, if
necessary, allow only the orange and red LED diodes working in a
flashing mode while the Multilogger is powered from batteries.
If you are not going to use the audio alarm signalization, turn it off.
Empty batteries can be easily recharged once the measurement is
completed using the fast charge option.
Recommended settings for the stationary application
_____
In this application, the Multilogger is powered from an external power
supply most of the time. It is required that the measurements and
recordings continue even during any power supply failure. Once the
power supply is restored, the data acquired during the given power
failure must be available and the batteries have to be automatically
recharged.
We recommend to use the Multilogger with NiMH accumulators;
specify the following device configuration:
NiMH accumulators (if they are installed).
Do not turn on the
Energy saving mode.
The Multilogger will
perform measurement with a fast sampling (1 second).
