CombiSteel 7485.0078, Instruction Manual

Page: 13 / 25

13
FUNCTIONING
1_SAFETY DEVICES PRESENT
The machine is equipped with adequate safety devices made of fixed guards, and an adequate distance
between the bowl and the machine casing, with the scope of avoiding contact of parts of the human body
(upper limbs) with the rotating bowl during the work phase, to eliminate the risks of dragging or crushing.
The machine is equipped with a lid sensor on the open bowl, with the scope of avoiding contact of parts of
the human body (upper limbs) with the moving parts during the work phase, to eliminate risks of dragging,
crushing and abrasion.
D
O NOT REMOVE THE GUARDS DURING USE OF THE MACHINE
. T
HE MANUFACTURER CANNOT BE HELD IN ANY WAY
LIABLE FOR NON
-
COMPLIANCE WITH THE AFOREMENTIONED INSTRUCTIONS
.
With reference to Figure 8, the guards are:
I – Moving protection grate
L – Device proving that the top and the protection cover are up or down (only on tilting head mixers)
M,M1 – Check pin of the top (down position, only on tilting head mixers)
N – Device proving that the bowl is in or out (only on tilting head mixers)
0 – Blocking disk of the bowl (only on tilting head mixers)
WARNING
The single safety device are efficient when:
-
On raising the protection I (PICT. 8) the machine stops.
-
On raising the top and/or taking off the bowl the machine does not start (only on mixers with tilting
head).
-
On softly pulling either the bowl or the top they do not move (only on mixers with tilting head).