CombiSteel 7485.0078, Instruction Manual

Page: 12 / 25

12
In the normal working conditions and to have the best exploration of the potentiality of the machine, the operator needs
the area represented in picture. Below:
3_INSTALLATION
The machine does not require any installation, other than connections when ready for use.
The machine must be connected to an electricity supply to work.
4_CONNECTIONS
Once positioned, connect the machine to the electricity mains, after:
•
ensuring the power and frequency of the electricity mains corresponds to that indicated on the plate;
•
be sure the power socket is connected to an earthing.
•
having assembled the cable, by specialist and trained staff, the relevant plug 16 ÷ 32 A, for a 3 pole
cable (Phase, Neutral and Earth) for the monophase versions, and with 5 poles (2 Phases, Neutral,
Earth) for the three-phase versions.
The manufacturer states that the electrical power supply line of the machine is equipped, upstream of the
machine, with protection via the differential switch, coordinate with the general, earthing switch, in
compliance with the local and national standards in force.
Check the guards on the machine are present and assembled before activating the machine.
Also check the spiral and the bowl both rotate in a clockwise direction: if this is not the case, invert
the arrangement of the phases.
If using the machine for the first time, clean it as described in the specific point.
C
ONNECT THE MACHINE ONLY TO THE BRANCHES OF THE ELECTRICAL SYSTEM INDIVIDUALLY PROTECTED
R
EFER TO THE ELECTRICITY STANDARDS OF THE COUNTRY IN WHICH THE MACHINE WAS INSTALLED
(
FOR
I
TALY REFER TO
L.D. 46/90)
D
O NOT REMOVE THE GUARDS DURING MACHINE USE
.