InteliATS
NT
PWR, SW version 2.5, ©ComAp
– May 2015
13
IA-NT- PWR-2.5-Reference Guide.pdf
N
OTE
:
Boot jumper programming
– In case of interrupted programming or other software failure is possible to
use the boot jumper programing to restore controller to working order. Connect controller to PC, run
LiteEdit and wait until connection bar at bottom turns red. Than run programming process via menu
Controller -> Programming and cloning
– Programming. Select correct firmware and confirm dialog.
Than follow instructions in LiteEdit.
Or follow video guide “
Boot Jumper Programming“
at
http://www.comap.cz/support/training/training-
videos/
.
IL-NT RS232-485 Communication module
IL-NT RS232-485 is optional plug-in card to enable InteliATS
NT
the RS232 and RS485 communication.
This is required for computer or Modbus connection. Card inserts into expansion slot back on the
controller. The IL-NT RS232-485 is a dual port module with RS232 and RS485 interfaces at
independent COM channels. The RS232 is connected to COM1 and RS485 to COM2.
To insert the module, please follow the instructions for IL-NT RS232 module, procedure is analogous.
You must open the cover first (use screwdriver to open) and then insert the module into slot. Once you
have inserted it, the module will snap under plastic teeth. It is supposed to be installed permanently.
Should you need to remove it, the safest way is to remove whole back cover and then remove module
manually.
RS485
Boot jumper
RS485 Terminator jumper
RS232
