Columbus Instruments 0184-006M, User Manual

Page: 22 / 39

20
5.3 Experiment Setup via Software Interface
1) From the Treadmill Software main window select
“Experiment » Run”.
2) This launches the “Experiment” window within the
“Profile Mode” tab as shown (F ‐ 33):
5.3.0 Utilizing Profile Mode
When a specific set of treadmill parameters will be revisited multiple times or will be recalled
for additional experimentation a profile may be desired.

First, select the “ Manual ” tab to observe that the “Enable
Profile Mode” box is checked (F ‐ 34). This ensures that a
profile will be properly recorded.

While in the “ Manual ” tab, if electrical stimulus is needed
select the desired “Number of Active Channels”
from the pull down menu located under the
Shock Detection settings (F ‐ 35).

Return to the “ Profile Mode ” tab to begin
creating a profile.
Figure 33
Figure 34
Figure 35