Chapter 5: Programming commands 117
A776-PG00001 D 07/13
A776 (B780) Programming Guide
Loading the exception table
The exception table begins at word 20 in NVRAM. Each entry takes five words. There is room for eight exceptions. An
application can load local exceptions into the printer using the write NVRAM command:
0x1B 0x73 n1 n2 k
which writes the two byte word n1:n2 to word k in NVRAM.
Exception table entry format
Each exception table entry consists of five words. The first two words contain the first eight characters of the transit
number by packing the low order nibble of the numeric transit number characters. For Canadian checks, eliminate the
dash and store the eight numerics.
The next three words are used as six individual bytes to tell the firmware how to interpret the MICR characters that fall
to the right of the rightmost transit symbol. Each of the six bytes is positional and consists of two parts: character type
and number.
The three high order bits of each byte mark the character type. The characters can be marked in three ways: check
serial # character, account # character, or “skip this character or symbol.”
The five low order bits of each byte contain the number of characters of that type to extract. Most exceptions will not
need to use all six bytes; in that case clear the unused bytes to zero.
Bits within byte
7 6
5 4
3 2 1 0
Check serial #
0 0
1 n
n n
n
n
character string
Account #
0 1
0 n
n n
n
n
character string
Character string
1 0
0 n
n n
n
n
to ignore
Example 1
t123456780t12349876543210o
1234 is the check serial #
9876543210 is the account #
To load the second table entry, which starts at word 25, the transit number 123456780 would be stored in the first two
words of its table entry using this string of commands:
0x1B 0x73 0x12 0x34 25
0x1B 0x73 0x56 0x78 26
After the right transit symbol are immediately the four characters of the check serial #, followed immediately by the
ten characters of the account number. These would be bitwise encoded as:
0 0 1 0 0 1 0 0 (check #, four characters)
and 0 1 0 0 1 0 1 0 (account #, 10 characters)
then stored in the other three words of the table entry using:
0x1B 0x73 0x24 0x4A 27
0x1B 0x73 0x00 0x00 28
0x1B 0x73 0x00 0x00 29
Summary of Contents for A776 ColorPOS
