CognitiveTPG A776 ColorPOS, Programming Manual

Page: 84 / 180

Chapter 5: Programming commands 72
A776 (B780) Programming Guide A776-PG00001 D 07/13
Set LogoEZ
®
attribute mapping (ColorPOS
®
)
ASCII US ETX ETB a m s
Hexadecimal
1F 03 17 a m s
Decimal 31 03 23 a m s
Values:
a = attribute map selector a , m, s = 0, 0, 0 turn off attribute mapping (all 3 bytes required)
a = 1 selects first attribute mapping definition (of two available)
a = 2 selects second attribute mapping definition
a = 1 or 2, if m = 0 mapping 1 or 2, respectively, is turned off
A word (2 bytes) is used to identify the attribute mapping, with “ m” bits 0 – 6 identifying which original attributes
should be mapped:
Original attribute mapped table
m bit on attribute mapped
0 Bold
1 Italic
2 Reverse
3 Underline
4 Double high
5 Double wide
6 Compressed print
The following “s” bits and “ m” bit 7 set the attributes that substitute for the mapped set:
Attributes substituted table
m bit on attributes substituted
7 Bold substituted
s bit on attributes substituted
0 Italic
1 Reverse
2 Underline
3 Double high
4 Double wide
5 Compressed print
6 Alternate color
7 Color reverse
This command configures into EEPROM (permanent configuration switch setting) one or two combinations of
character attribute mappings, including substitute attribute settings for color effects. The attributes of the character
code are used to form the desired pixel character when the code is placed into the raster print buffer. An “
m ” bit value
set to on in the “original attribute mapped table” above will have its attributes set to the corresponding bit value of “ s”
in the “attributes substituted table”. If m = 0 then no substitution takes place.
The command is available only in A776 native mode. Once attributes have been defined and enabled they can be
used in any emulation mode. A776 native mode must be used to turn the feature off.
Continued . . .