Many of the operations described later in this manual can only be performed with the projector housing opened..
To access the internals of the projector, proceed as follows:
1) Using a Philips head screwdriver, loosen and remove the 11 screws (
A
) which affix the rear housing (
B
) of the projector body.
Care should be taken during this operation to not drop and lose the screws.
2) Remove the cover (
B
) from the central seal.
3)You should now have access to the internals of the unit and may carry out the instructions detailed below.
Important Note:
To close the unit, you must ensure that the rear cover (
B
) is properly seated in the central seal (
C
) and then replace and
fasten the 11 screws. The
Panorama Cyc 250 C
will only maintain its weather-resistance if this procedure is carried out
with scrupulous attention to detail.
Attention!
Turn off the power prior to opening up the unit.
The fixture’s internal temperature may reach 250° C after 5 minutes, with a maximum peak of 350°C.Ensure the lamp is cold
prior to attempting removal. The fixture should be allowed to stand and cool for 10 minutes prior to its removal.
4. Opening the projector
4
English