5. Have the hearing person listen to the sound. Note that monitor
earphones only indicate that sound can be heard: they do not
indicate the quality of the sound heard by the processor user.
If you attach the accessory after you have pressed the Increase and
Decrease buttons, press them again to activate the accessory.
Press any button to continue the sounds through the monitor
earphones. The sound will stop when no buttons have been pressed
for 90 seconds. To re-start the sound in the monitor earphones,
press both the Increase and Decrease buttons again for a few
seconds.
Accessories and the telecoil
When you are using an accessory with your processor, it is possible
to switch to the in-built telecoil or the microphone only setting, with
the accessory still attached to your processor. For example, if you are
using your TV/Hi-Fi cable and then wish to use a telephone with a
telecoil induction loop, you can switch to the in-built telecoil setting
while the TV/Hi-Fi cable is still attached.
This set of actions is part of a cycle. Each time you push both the
Increase and Decrease buttons at the same time, for a few seconds,
you move on to the next setting. Starting from where you can
hear the accessory, by pushing the buttons you move to the in-built
telecoil, then to the microphone and finally return to the accessory.
To skip a setting, push the buttons a second time.
When an accessory is not attached the cycle is microphone – telecoil
– microphone.
�
The accessories mentioned cannot be used with the BTE Mini
Controller because it does not have an accessory socket.
Certain accessories may not be available in all countries.
52 - Nucleus Freedom User Manual
© Cochlear Limited 2014
A
cce
ss
o
ri
e
s
N206305-206317_4.01_Freedom_User_Manual_ENG_CAP_SC.indd 52
10/07/2014 11:12:26 AM