COBHAM SAILOR 6120, Installation Manual

Page: 81 / 116

Chapter 4: Configuration
SSA buttons configuration (SAILOR 6120 only) 69
4444
Configuration
4.6.1.7 To route covert alert messages and test messages
To configure to which addresses the alert messages and test messages
should be routed, use the following command:
Syntax: se -ame (entry),(usage)[,(cfg)]
•
entry
: 0...5
•
usage
:
1: Message (message only)
2: Test (test only)
3: M test (both message and test)
•
Cfg
(Optional): Used to determine whether or not a configuration
change message should be sent to the address of this entry, that is to
inform the recipient that a SSAS configuration change has been made.
0: Do not send configuration change message
1: Send a configuration change message to the address configured for
this entry.
Example:
: se -ame 0,1,1
• entry = 0 (for the first entry)
• usage = 1 (for message only)
• cfg = 1 (send configuration change message to the address for this
entry)
4.6.1.8 To select the preferred LES
Enter the preferred LESes for all ocean regions with the following
command:
: se -m <LES ID for AORW>, <LES ID for AORE>, <LES
ID for POR>, <LES ID for IOR>
.
Note
• The first address (entry=0) can receive alert messages only.
• The second address (entry=1) can receive both alert and test
messages.
• The third address (entry=2) can receive test messages only.