Operating Instructions
RaptorX-SL-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 63
Support: +49 (0)2831/91021-50
06.10.2010
Table top height adjustment
1.
Remove the table top from the support struts.
2.
Loosen Allan screws on each support strut using the correct
Allan key.
3.
Move support struts to the correct height and refasten.
The supports struts may be inverted.
4.
Replace the table top on the support struts and refasten.
5.
Use the spirit-level to check that the table top is level in the
x- and Y-directions.
6 . 3
I n s t a l l a t i o n
6 . 3 . 1
Connecti ng the C o mputer
Fig. 27:Connection to Computer
The computer will be connected to the machine via a DSUB-25-
pin parallel connection (Fig. 27/1). The other side will be con-
nected to the computer via a parallel port connection.
Depending on the type of software used (e. g. WinPCNC USB
or WinPCNC Profi) the connection to the computer may be via
USB port or serial port.
Staff
Operator
1.
Attach cable from computer to the controller (Fig. 27/1).
2.
Ensure that all cables have been screwed into their connect-
ors securely.