All content © 2018, cmotion GmbH. All specifications are subject to change without further notice.
http://www.cmotion.eu
page 48 of 80
Move the control interface assigned to focus (knob as default) to the next line and value
on your lens.
If you move the lens from the last set value in one direction (in this case down, towards
close focus), the lens wizard will predict the next value.
If the predicted value is not a value marked on your lens, use the thumb wheel to scroll
clockwise or counter-clockwise until you see the desired value in the blue input box. As
an alternative, you can also swipe the touch screen up or down.
Once the desired value is highlighted in the blue input box, press “set” (MB2) and the
value mark will be set on the grafical scale bar. As an alternative, you can also tap the
touch screen to confirm your selection or press the back button (BB1).
Continue this procedure until you have set all important values on your lens.
Note: It is not necessary to assign every single lens value because the cPRO system will
predict missing values automatically. However, to achieve the best matching lens data, it is
recommended to input and assign as many values as possible using this procedure.
If a lens value is not displayed in the predicted list, press UB3 to change the resolution of
the input box. This allows you to enter any value. The text “UB3:resolution” will illuminate
green while the high resolution remains active. Press UB3 again to return to the original
resolution.
As long as a value is highlighted in yellow, you can delete it by pressing UB2. You can also
reposition the mark by moving lens to the new position and pressing “set” (MB2), tapping
the touch screen or pressing the back button (BB1).
UB1 allows you to set lines (without a value) in order to create a perfect animated depiction
of your lens. Lines can either be added between values or added separately after all the
values have been created.