CMCO YaleERGO 1500, Translated Operating Instructions

Page: 30 / 96

30
©
2016 Columbus McKinnon Industrial Products GmbH
T
RANSPORT
, S
TORAGE
, D
ECOMMISSIONING AND
D
ISPOSAL
Observe the following for transporting the unit:
• Do not drop or throw the unit, always deposit it carefully.
• Load chains must be transported in a way to avoid knotting and formation of loops.
• Use suitable transport means. These depend on the local conditions.
Observe the following for storing or temporarily taking the unit out of service:
• Store the unit at a clean and dry place.
• Protect the unit incl. all accessories against contamination, humidity and damage by means
of a suitable cover.
• Protect hooks against corrosion.
• A light lubricant film should be applied to the chain.
ATTENTION: It must be ensured that no lubricant can penetrate into the brake
enclosure. This may result in failure of the brake.
• Since the brake disks may freeze at temperature below 0 °C, the unit should be stored with
closed brake. For this purpose, move the change-over lever to lifting (
↑
) and operate the
hand lever with a pumping action, while holding the load fall.
• If the unit is to be used again after it has been taken out of service, it must first be inspected
again by a competent person.
Disposal
After taking the unit out of service, recycle or dispose of the parts of the unit in accordance
with the legal regulations.
Further information and operating instructions for download can be found at
www.cmco.eu!