30
Single Point Watering System (SPWS)
BATTERIES: ELECTRIC VEHICLE WITH
ERIC CHARGING
1
2
3
5
4
5
7
6
8
3
68
Figure 30-4
Connecting Hose with Filter to Water Source
725
Figure 30-5
Checking the Water Flow Rate
4.
Completely open the water faucet until the water flows out of the hose-end assembly (3), and note the movement
of the red flow indicator balls (6).
See following NOTE.
NOTE:
The water flow rate must be at least two gallons-per-minute for the SPWS to function properly.
This step also eliminates any trapped air from the water hose.
5.
Check the water quality light on the deionizer to make sure the light is green in color, indicating acceptable water
quality. If the light indicates unacceptable water quality, the cartridge must be replaced.
6.
After ensuring adequate water flow rate, press the grey button (7) on the end of the female coupler (8) to
disconnect the purger from the pressure regulator.
Refilling the Batteries
1.
Locate the battery fill coupling (9) on the driver side of the battery compartment, remove the dust cover (10) from
the male connector
, and connect the hose-end assembly (3)
. The water flow
will begin immediately.
10
9
8
9
3
70
Figure 30-6
Dust Cap
71
Figure 30-7
Connecting Hose-end Assembly to Battery
Fill Connector
2.
The red flow indicator balls should swirl, indicating that the batteries are being filled.
See following CAUTION.
Page 30-12
2014 Precedent
®
Golf Car Maintenance and Service Manual
Summary of Contents for Precedent 2014
