Club Car Precedent 2014, Maintenance And Service Manual

Page: 260 / 548

18
Transaxle Disassembly, Inspection, and Assembly TRANSAXLE: ELECTRIC VEHICLE
8. Disassemble the differential gear case:
8.1. Remove the hex bolts (33) and the ring gear (32) from the differential case (Figure 18-5, Page 18-3) .
8.2. Remove the ring gear.
8.3. Separate the differential gear case housing. If necessary, install two of the hex bolts (removed previously in
step 8.1.) into the differential gear unit and, while holding the unit slightly above the work area, lightly tap
the bolt heads
(Figure 18-13, Page 18-8) . Remove the two bolts.
772
Figure 18-13 Separate Housing
8.4. Remove the differential pin (31) by pushing pin through differential gear case from one side (Figure 18-5,
Page 18-3) . See also Figure 18-14, Page 18-8.
8.5. Remove the idler gears (1 and 2) and thrust plates (3 and 4) (Figure 18-15, Page 18-8) .
1
5
6
26
2
8
7
3
4
773
Figure 18-14 Differential Pin
774
Figure 18-15 Left Differential
8.6. Remove the differential gears (5 and 6) and thrust plates (7 and 8).
8.7. Inspect the bearings (13) of the differential case (26) and replace them if they are damaged (Figure 18-5,
Page 18-3) . To remove them, press them off. See following CAUTION.
CAUTION
• Do not reuse bearings after removing them. Replace bearings with new ones.
9. Inspect parts for wear or damage. Any worn or damaged parts should be replaced. See following NOTE.
NOTE: Damaged or worn gears should be replaced as sets.
Page 18-8 2014 Precedent ® Golf Car Maintenance and Service Manual