Club Car Precedent 2014, Maintenance And Service Manual

Page: 210 / 548

14
Onboard Computer (OBC)
ELECTRICAL COMPONENTS: ELECTRIC
VEHICLE WITH POWERDRIVE CHARGER
5. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-4.
ONBOARD COMPUTER (OBC)
See General Warnings on page 1-2.
TESTING THE ONBOARD COMPUTER
See Test Procedure 2 – Onboard Computer Solenoid Lockout Circuit on page 13-15, Test Procedure 18 –
Onboard Computer Silicon-Controlled Rectifier (SCR) Circuit on page 13-32, and Test Procedure 19 – Onboard
Computer Gray Wire on page 13-33.
ONBOARD COMPUTER REMOVAL
1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-4.
2. Remove the batteries from the vehicle to provide enough room to access the OBC (15) (Figure 14-8, Page
14-11) . See Battery Replacement on page 15-9.
3. Remove the bolt (11) that secures the electronics module to the battery bucket.
4. Pull electronics module forward and disconnect the wires from OBC.
5. Disconnect the 6 gauge black wire, that passes through the OBC, from the B- terminal on the controller.
6. Loosen, but do not remove, the two self-tapping screws (12) holding OBC to component mounting plate(14).
7. Slide OBC upwards to align heads of self-tapping screws (12) with the two key holes in the OBC face plate
and remove OBC.
ONBOARD COMPUTER INSTALLATION
1. Install the OBC onto the component mounting plate by engaging the two key holes on the OBC face plate with the
self-tapping screws (12)
(Figure 14-8, Page 14-11) . Tighten screws to 5.5 ft·lb (7.5 N·m).
2. Connect wires per the electrical schematics. See Wiring Diagrams on page 13-3. Make sure all connections are
fully seated and boot on gray sense lead is properly seated.
3. Return electronics module to its original location and secure with bolt (11). Tighten bolt to 40 in·lb (4.5 N·m).
4. Install the batteries and battery cables in their original locations. See Battery Replacement on page 15-9.
5. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-4.
Page 14-14 2014 Precedent ® Golf Car Maintenance and Service Manual