MOTOR (MODEL EJ8-4001A): ELECTRIC VEHICLE
Motor
17
9.1. Place the end cap in a press with the armature facing down.
9.2. Place a bearing press tool with an outer diameter smaller than that of the armature shaft between the press
ram and the armature shaft
9.3. Have an assistant support the armature while the press is activated.
10. Inspect the armature for wear and damage.
See Armature Inspection and Testing on page 17-8.
11. Inspect the motor frame and field windings.
See Motor Frame and Field Windings Inspection on page 17-10.
12. Remove the brush rigging.
12.1. Mark the brush terminal posts (A1 and A2).
12.2. Remove the two nuts securing the brush terminals (A1 and A2) to the end cap
12.3. Remove the two screws and the brush rigging to the end cap
.
13. Inspect the terminal insulators.
See Terminal Insulator Inspection on page 17-10.
14. Remove the bearing from the end cap.
14.1. Remove the retaining ring that secures the bearing in the end cap
.
14.2. Use an arbor press to remove the bearing from the end cap.
15. Inspect the bearing for wear and damage.
See Bearing Inspection on page 17-11.
752
Figure 17-8
Armature Removal
753
Figure 17-9
A1 and A2 Terminals
2014 Precedent
®
Golf Car Maintenance and Service Manual
Page 17-7
Summary of Contents for Precedent 2014
