24
Unitized Transaxle Removal
UNITIZED TRANSAXLE (GASOLINE VEHICLE)
1
1
2398
Figure 24-19
Throttle Cable Mounting
565
Figure 24-20
Engine Ground Wire
4.7. Use a screwdriver or flat blade to snap the shifter cable rod end (1) from the shifter arm (2) on the unitized
transaxle. Compress the retaining clips (3) on the cable anchor and push the cable through the shifter
bracket
4.8. Mark for identification and then disconnect the 6-gauge white wire (F2 post), 6-gauge black ground wire (A2
post), and 16-gauge yellow wire (DF post) from starter/generator
1
2
3
DF
F2
DF
1
2
3
1. Yellow Wire 2. White Wire 3. Ground Wire at A2 Terminal
2399
Figure 24-21
Shifter Cable (Top View)
1350
Figure 24-22
Generator Wires – Model 114-01-4005 shown
4.9. Disconnect the engine oil level sensor wire (18-gauge yellow) at the connector just to the rear of the
starter/generator
.
4.10. Disconnect the engine kill switch wire (18-gauge white/black) from the bullet connector at the lower right
front of the engine
4.11. Cut away the wire ties securing the engine kill wire at the lower right front of the engine (below the exhaust
header), the wire harness at the governor cable bracket, and the wire harness to the plate beneath the
muffler.
Page 24-12
2014 Precedent
®
Golf Car Maintenance and Service Manual
Summary of Contents for Precedent 2014
