Installation Guide_PV-ezRack_SolarTerraceII-A_AU_V2.0
1/10 Duerdin Street, Clayton VIC 3168 Australia
Tel: +61 3 9239 8088 Fax: +61 3 9239 8024
E-mail: [email protected] www.clenergy.com.au
17
page
of 21
Installation Instruction
5.8.2 Place PV Modules on Rails, and fix them with End Clamps and Inter Clamps or Universal
Clamps, then fasten them with Allen Key. Please choose below Solution 1 or 2 according to your
project.
-Solution 1 (Apply End Clamps and Inter Clamps)
Step 1 Place the first PV Module on T Rails according to your plan and apply the End Clamps to fix it
and then fasten lightly with Allen Key as shown in figure below .
Step2 Slightly lift the PV Module and
slide Inter Clamps and Grounding
Clips into position. The teeth on
Grounding Clip will automatically
align when the Inter Clamp is properly
installed as shown in right Figure.
Step 3 Loosely place the next framed
PV Module into the other side of Inter
Clamp and Grounding Clip as shown
in right Figure.
Important Notes:
-To fix Grounding Clip properly, ensure the frames of PV Modules are completely pressed
against the Inter Clamp and Grounding Clip. Visually check that Grounding Clips are positioned
properly.
-Grounding Clips are intended for SINGLE USE ONLY! Do not fasten the bolts down if the
position of PV Module is not finalized. Only slightly tighten bolts to keep PV Modules in place.
Fig. 19
Fig. 20
Fig. 21
