CleaverBrooks profire q, Installation, Operation And Maintanance

Page: 5 / 58

PREFACE
It is the responsibility of the owner of this equipment to post and maintain a legible copy of this
Installation, Operation and Maintenance manual while this equipment is in service.
Warning and caution references have been made in this manual and should be adhered to for smooth
operation of the burner.
Model designations are based on the type of fuel(s) to be fired and the amount of furnace pressure to be
overcome. Burner size is based on firing rate (rated input in Btu/hr).
The equipment must be installed in accordance with applicable local, state, or Provincial Installation
Requirements including the National Electrical Code (NEC) and Associated Insurance Underwriters.
Where applicable, the equipment shall be installed in accordance with the Provincial Installation
Requirements, or in their absence, the Canadian Gas Association (CGA) B149.1 and B149.2 and Canadian
Standard Association (CSA) B140 and B139 (for oil burners) Installation Codes shall prevail. Authorities
having jurisdiction should be consulted before installations are made. Oil and gas burning equipment shall
be connected to flues having sufficient draft at all times to assure safe and proper operation of the burner.
The Q Series burners are designed to burn gas only as defined by ASTM D396-2010 specifications.
This symbol precedes information which, if disregarded, may result in injury to the user of the burner or to
others.
This symbol precedes information which, if disregarded, may result in damage to the burner.
NOTE: This symbol precedes information which is vital to the operation or maintenance of the burner.
Model Standards Fuel-Air Atomization
Q Gas
NOTE: The gas train components ship loose, therefore, the bleed valve will need to be installed and adjusted
in the field. Refer to Chapter 4, section 4-2 for adjustment information.
! Warning
! Caution