Clarke MIG 240, Operation & Maintenance Instructions Manual

Page: 8 / 28

8
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
ELECTRICAL CONNECTIONS
A STANDARD 13AMP PLUG MUST NOT BE USED WITH TH
I
S
UNIT.
The unit must be connected to a 230V socket cabable of supplying 32 Amps,
We recommend that you consult a qualified electrician and connect the
mains lead, through a suitably fused isolator switch
Before switching the product on, make sure that the voltage of your electricity
supply is the same as that indicated on the rating plate. This product is
designed to operate on 230VAC 50Hz. Connecting it to any other power
source may cause damage.
If the colours of the wires in the power cable of this product do not correspond
with the markings on the terminals of your plug, proceed as follows.
• The wire which is coloured Blue must be connected to the terminal
which is marked N or coloured Black .
• The wire which is coloured Brown must be connected to the terminal
which is marked L or coloured Red .
• The wire which is coloured Yellow and Green must be connected to
the terminal which is marked E or or coloured Green .
We strongly recommend that this machine is connected to the mains supply via
a Residual Current Device (RCD)
If in any doubt, consult a qualified electrician. DO NOT attempt any repairs
yourself.
WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS
THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS
SUPPLY.
WARNING: THE WIRES IN THE POWER CABLE OF THIS PRODUCT ARE
COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
BLUE = NEUTRAL BROWN = LIVE YELLOW AND GREEN = EARTH