16
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
6. Close the side panel of the
welder.
7. Pull off the torch shroud with a
twisting movement, then unscrew
the contact tip.
8. Connect the welder to the power
supply and switch ON.
9. Set the ‘WIRE FEED’ rotary control
on the front panel to position 7 or
8 and squeeze the trigger on the
torch body.
• The wire will feed through the
hose until it appears at the
torch tip.
• Ensuring the hose is free from
kinks during this process will
assist the wire in its passage
through the hose liner.
10. Release the trigger and switch off the welder and disconnect the machine
from the mains supply.
11. Refit the appropriate size contact tip to suit your wire. then replace the
shroud.
• Spare tips or various sizes are supplied loose and should be used
when appropriate.
12. Trim the welding wire so that it protrudes no more than 5 mm from the end
of the contact tip.
Summary of Contents for MIG 240
Page 28: ......
