14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PREPARATION FOR USE
MOUNTING THE WELDING WIRE SPOOL
NOTE:
Spools of welding wire are available from your Clarke dealer.
1. Open the side panel by pushing
the latch down and allowing the
side panel to open.
2. Remove the locking screw and
retaining spring.
3. Place the spool of welding wire
(not supplied) over the spindle.
• Do not release the tension on
the wire as it will unravel,
causing feeding problems later.
• The wire will feed off the spool clockwise from the top of the reel.
• The spool must be fitted with the correct orientation otherwise it will
not feed correctly.
4. Replace the retaining spring and locking screw.
SETTING THE DRIVE ROLLER SIZE
1. Loosen the tensioning knob and
pivot it towards you.
2. Lift up the arm.
3. Remove the drive roller
thumbscrew.
4. Pull the roller retainer off the drive
spindle to reveal the roller.
WARNING: MAKE SURE THAT THE WELDER IS NOT CONNECTED TO THE
MAINS SUPPLY.
Summary of Contents for MIG 240
Page 28: ......
