Clarke ENCORE MAX, Operator'S Manual & Parts List, Page: 45 / 61

CLARKE 1-45
ENCORE MAX
ADJUSTMENT
CASTORS
SQUEEGEE CASTER WHEEL ADJUSTMENT
Adjust if squeegee leaves water on floor. The wheels must be 3/16" (.476 cm) above the floor.
1. Set the parking brake.
2. Turn the key switch to the on position.
3. Put the Squeegee Blade Switch in the lower position.
4. Turn the key switch to the on position. This will turn off the vacuum fans.
5. Loosen the wheel brackets by turning the adjustment handles.
6. Adjust the wheels to 3/16" (.476 cm) above the floor.
7. Tighten the wheel brackets with the adjustment handles.
SQUEEGEE KNOB
Fig. 58
MAINTENANCE FOR THE REAR SQUEEGEE
To remove the squeegee, follow this procedure:
1. Remove the squeegee assembly by loosening the two knobs that attach the squeegee to the
machine as shown in figure 59. Pull the squeegee assembly off.
2. Inspect the squeegee blade.
3. If the blade is worn, turn the blade so that a new edge is in the wiping position.
4. Reinstall squeegee assembly on the machine.
Note
Toothed lock washers must be on top of support plate
Fig. 59
MAINTENANCE