Clarke ENCORE MAX, Operator'S Manual & Parts List, Page: 44 / 61

1-44 CLARKE
ENCORE MAX
DISK SCRUB BRUSH
SQUEEGEE PIN
SIDE SQUEEGEE
BRUSH BRISTLES
SHOULD NOT
BE LESS THAN
3/4” HIGH
DISK SCRUB BUSHES
REPLACING THE SCRUB BRUSHES
Replace Scrub Brushes when the bristles become worn to 3/4" as shown in figure 56 and 57.
1. Lower scrub brushes.
2. Swing open side squeegees
3. Lift scrub brushes
4. The scrub brush is held in place by a ring. Pull the brush straight down to remove it.
5. Push a new brush onto the scrub brush driver until it clicks in place.
6. Lower Scrub Deck to the NORMAL position and check the brush for proper floor contact.
7. Replace side squeegees.
REPLACING PADS ON A PAD DRIVER
Install a new pad when the old pad is worn or dirty. The pad driver assembly is removed and installed the same
way a standard scrub brush is. (See replacing the scrub brushes) To change pad follow this procedure.
1. The pad driver is held in place by a ring. Pull the pad driver straight down to remove it.
2. Remove the pad holder using the spring wire retainer.
3. Replace the worn pad.
Fig. 56
Fig. 57
MAINTENANCE