Clarke ENCORE MAX, Operator'S Manual & Parts List, Page: 18 / 61

1-18 CLARKE
ENCORE MAX
METAL BAR
BRAKE RELEASE LEVER
ELECTRICALLY ACTUATED
MECHANICAL PARKING BRAKE
MACHINE PREPARATION
Fig. 3
WARNING
Disconnect the traction harness before towing the machine.
6) The machine is shipped with a metal bar between the electrically actuated parking brake and the brake
release lever to keep the electrically actuated parking brake disengaged.
7) Push machine down the ramp onto a flat surface.
WARNING
8) Remove the metal bar to engage the electrically actuated mechanical parking brake.
9) Connect rear squeegee hose and install squeegee blade as shown in manual.
10) Remove battery charger from under the seat in battery compartment (if applicable).
11) Install batteries.
-Turn the key to the “O” position
-Lift the hinged seat and cover, then disconnect seat switch and remove seat plate.
-Use a battery lifting device with a 150 LB. (68KG) capacity to place the batteries battery compartment.
-Install Battery wires as shown in manual.
-Plug the polarized connector from the battery on into the 36 Volt plug provided.
-Install scrub brushes as shown in the manual.
-Lower seat and cover assembly.
12) Charge batteries as shown in the manual. Read battery manufacturer literature for battery care and
maintenance.
WARNING
Do not charge batteries on a concrete grounded surface. Hydrogen gas is formed during the charging
operation and is explosive. Only charge batteries in a well ventilated area with the lid open. Avoid
any smoking, open flame, or electrical sparks.
DISCONNECT TRACTION
HARNESS CABLE BEFORE
TOWING THE MACHINE
Fig. 4