13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ADJUSTING THE FORCE
Chisel force may be adjusted by
turning the regulator knob, located at
the base of the handle.
• Turn anticlockwise to increase
force.
• Turn clockwise to reduce the
force.
USING THE CHIPPING HAMMER
1. Hold the tool firmly, then bring the
tool towards the work at an angle
of approximately 60-70 degrees.
2. Squeeze the trigger with the chisel
in light contact with the work.
3. Move slowly across the work
surface. To remove scale, rust or
other contaminants, only a light
force should be required.
4. Release the trigger to stop
operation whilst maintaining contact with the work.
5. The tool may operate briefly after the trigger is released.
NOTE:
The retaining spring has a life expectancy, depending upon the
intensity of usage. It is recommended that you procure a spare
spring for use in the event of failure occurring during the course of
a particular job.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air hose until the supply is isolated at a shut-off
valve.
2. Once the pressure has been isolated, disconnect the air supply hose.
3. Shut down the compressor at the end of the work session.
Summary of Contents for 3110876
Page 32: ......
