19
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4. DO NOT operate tool with spindle in locked mode as performance would
be severely affected and a hazardous situation may result.
FITTING THE SANDING SHEET
1. Peel off the back of the self adhesive sanding sheet and stick it to the
backing pad.
ADJUSTING THE SPEED
Adjust the operating speed if
required, by twisting the speed
control.
• Clockwise to increase the
sanding speed.
• Anticlockwise to decrease the
sanding speed.
USING THE SANDER
1. Place the sander on the workpiece and press down on the trigger to start
the sander.
2. Release pressure from the trigger to stop the sander.
3. Always ensure the sander has stopped before putting it down on any
surface after use.
4. Avoid contact with the moving sanding pad and wear suitable gloves to
protect the hands.
5. Never start the sander unless the abrasive pad is applied to the workpiece.
6. Always wear a face mask when using the sander as protection from
airborne particles of sanded material. Avoid disturbing existing dust and
minimise the scattering of dust in the workplace environment. Take steps to
control the dust at the point of emission.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the hose until the supply is isolated at a shut-off valve.
2. Once the pressure has been isolated, disconnect the air supply hose.
3. Shut down the compressor at the end of the session.
Summary of Contents for 3110876
Page 32: ......
