38
SECTION 23: ELECTRIC MOTOR, ESC AND BATTERY INSTALLATION
❑
(2) Engine Mounting Beams
❑
(4) M3 x 18mm Machine Screws
❑
(4) Motor Mounting Straps
❑
(4) M3 x 12mm Wood Screws
❑
(8) M3 Flat Washers
❑
(4) M3 Blind Nuts
❑
(2) Plywood Mounting Plates
YOU'LL NEED THE FOLLOWING PARTS FROM THE KIT:
❑
Kwik Bond 5 Minute Epoxy
❑
# 2 Phillips Head Screwdriver
❑
Electric Drill
❑
3/32" & 5/32" Drill Bits
❑
Ernst Airplane Stand
❑
Ruler
❑
Pencil
❑
Paper Towels
❑
Rubbing Alcohol
❑
NHP Epoxy Mixing Sticks
❑
NHP Epoxy Mixing Cups
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
❑
Using a ruler and a pencil, measure out 13/16" and draw one vertical
line to the right of the vertical thrust line and one vertical line to the left of
the vertical thrust line.
☞
Make sure that the two vertical lines you draw are parallel to the
vertical thrust line.
STEP 1: INSTALLING THE MOTOR MOUNTING BEAMS
✦
✦
✦
✦
✦
IMPORTANT
✦
✦
✦
✦
✦
To aid in alignment, the horizontal and vertical thrust lines have been predrawn onto the firewall for you.
❑
Using a ruler and a pencil, measure and draw a horizontal line 1/2"
above the horizontal thrust line, then measure and draw a horizontal
line 13/16" below the horizontal thrust line.
☞
Again, make sure that the two horizontal lines you draw are parallel
to the horizontal thrust line.
Continued On Next Page
☛
☛
☛
☛
☛
❑
Using a drill with a 5/32" diameter drill bit, drill a hole through the
firewall at each of the four intersecting lines.
