22
❑
While keeping the axle centered, carefully slide one nylon spacer
onto each end of the axle and push them up against the ends of the
aluminum tube.
❑
Slide one wheel onto each end of the axle. Secure the wheels into
place, using two wheel collars and two M3 x 6mm machine screws.
☞
We suggest applying Blue Threadlocker to the machine screws to
prevent them from loosening during flight.
✦
✦
✦
✦
✦
IMPORTANT
✦
✦
✦
✦
✦
After installing the wheel collars, double-check that
both wheels spin freely.
STEP 3: INSTALLING THE TAIL WHEEL
❑
Slide the nylon spacer onto the tail wheel wire, followed by the tail
wheel. Use the wheel collar and one M3 x 5mm machine screw to hold
the tail wheel in place.
SECTION 12: ENGINE INSTALLATION
❑
(2) Engine Mounting Beams
❑
(4) M3 x 18mm Machine Screws
❑
(4) M3 x 25mm Socket-Cap Screws
❑
(4) M3 Lock Nuts
❑
(4) M3 Blind Nuts
❑
(12) M3 Flat Washers
YOU'LL NEED THE FOLLOWING PARTS FROM THE KIT:
❑
Kwik Bond Thick C/A
❑
# 2 Phillips Head Screwdriver
❑
2.5mm Hex Wrench
❑
Adjustable Wrench
❑
Electric Drill
❑
5/64", 1/8" & 5/32" Drill Bits
❑
Ruler
❑
Pencil
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
✦
✦
✦
✦
✦
IMPORTANT
✦
✦
✦
✦
✦
This section details the installation of a glow engine. If you will be installing an electric motor, please refer to
Section 23 on page # 38 at this time.
Continued On Next Page
☛
☛
☛
☛
☛
