![Citrix ByteMobile T1010 Installation, Configuration And Administration Download Page 88](http://html1.mh-extra.com/html/citrix/bytemobile-t1010/bytemobile-t1010_installation-configuration-and-administration_2611003088.webp)
3-14
T-Series Traffic Director Installation, Configuration and Administration Guide
Chapter 3 Basic T1000/Unison Load-Balancing Configuration
Configuring Trunking
A trunk interface binds two or more interfaces together for increased bandwidth over a link
and/or increased fault tolerance. The T1000 divides traffic equally between the interfaces.
Use the
set interface
,
set channel
, and
set lacp
commands to create a trunk (LACP)
interface on the ports connected to the Unison blade switch.
The following example shows how to use
set interface
to apply LACP mode and assign an
LACP key to the interfaces that will be trunked together:
>
set interface 10/1 -tagall ON -lacpMode ACTIVE -lacpKey 1 -throughput 0
-bandwidthHigh 0 -bandwidthNormal 0
Done
>
set interface 10/2 -tagall ON -lacpMode ACTIVE -lacpKey 1 -throughput 0
-bandwidthHigh 0 -bandwidthNormal 0
Done
The
set channel
command configures the trunk port. It has the following syntax:
set channel
id
[
-state
{ENABLED | DISABLED}] [
-speed
speed
] [
-flowControl
flowControl
] [
-haMonitor
{ON | OFF}] [
-tagall
{ON | OFF}] [
-ifAlias
string
]
[
-throughput
positive_integer
] [
-bandwidthHigh
positive_integer
[
-bandwidthNormal
positive_integer
]]
Using the example configuration:
>
set channel LA/1 -tagall ON -throughput 0 -bandwidthHigh 0 -bandwidthNormal 0
Done
The
set lacp
command configures the LACP system priority for the trunk, using integers
from 1 to 65335. It has the following syntax:
set lacp
-sysPriority
positive_integer
Using the example configuration:
>
set lacp -sysPriority 32768
Done
Configuring VLANs
The example deployment in this chapter uses eight VLANs in total: four ingress and four
egress.
Use the
add vlan
command to add the VLANs, and the
bind vlan
command to bind a
VLAN to an interface. These commands have the following syntax:
To add a VLAN ID:
add vlan
id
[
-aliasName
string
]
To bind a VLAN to an interface:
bind vlan
id
[
-ifnum
interface_name
... [
-tagged
]]
Summary of Contents for ByteMobile T1010
Page 10: ...x T Series Traffic Director Installation Configuration and Administration Guide...
Page 14: ...Contents xiv T Series Traffic Director Installation Configuration and Administration Guide...
Page 172: ...Index Index 4 T Series Traffic Director Installation Configuration and Administration Guide...