Citrix ByteMobile T1010, Installation, Configuration And Administration

Page: 5 / 172

T-Series Traffic Director Installation, Configuration and Administration Guide v
• Connect and disconnect cables as described in the following table when
installing, moving, or opening covers on this product or attached devices.
Statement 3
Caution: When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
• Do not remove the covers. Removing the covers of the laser product could result in
exposure to hazardous laser radiation. There are no serviceable parts inside the
device.
• Use of controls or adjustments or performance of procedures other than those
specified herein might result in hazardous radiation exposure.
Danger:
Some laser products contain an embedded Class 3A or Class 3B laser diode.
Note the following:
Laser radiation when open. Do not stare into the beam, do not view directly
with optical instruments, and avoid direct exposure to the beam.
To Connect: To Disconnect:
1. Turn OFF all power sources and
equipment to be attached to this
product.
2. Attach all cables to the devices.
3. Attach signal cables to the
connectors.
4. Attach power cords to power
sources. For DC systems, ensure
correct polarity of -48VDC
connections: RTN is (+) and
-48VDC is (-). Earth ground should
use a two-hole lug for safety.
5. Turn ON all the power sources.
1. Turn OFF all power sources and
equipment to be attached to this
product.
• For AC systems, remove all power
cords from the shelf power
receptacles or interrupt power at the
ac power distribution unit.
• For DC system systems, disconnect
DC power sources at the breaker
panel or by turning off the power
source, then remove the DC cables.
2. Remove the signal cables from the
connectors.
3. Remove all cables from the devices
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
Appareil A Laser de Classe 1
`