2-10
T-Series Traffic Director Installation, Configuration and Administration Guide
Chapter 2 Installing the T1000
For round-hold, threaded racks, remove the studs and discard. Secure the rail to the rack by
using the flathead screws that were holding the studs in place. For square-hole and
round-hole non-threaded racks, insert studs into hole in the rear of the rack.
Figure 2-3
Installing the Rail Assembly to the Rack
Installing the T1000 in the Rack
Step 1
Align the inner rails, attached to the T1000, with the rack rails.
Step 2
Slide the T1000 into the rack rails, keeping the pressure even on both sides.
Step 3
Verify that the T1000 is locked in place by pulling it forward out of the rack.
Note:
The following figure shows the T1100 hardware model. Procedure and rail
location are similar for T1010 and T1200 models.
Summary of Contents for ByteMobile T1010
Page 10: ...x T Series Traffic Director Installation Configuration and Administration Guide...
Page 14: ...Contents xiv T Series Traffic Director Installation Configuration and Administration Guide...
Page 172: ...Index Index 4 T Series Traffic Director Installation Configuration and Administration Guide...
