Printer Operation
35
Top Menu
Sub Menu
Default
Menu
Remarks
Max Media Length
[Max Media Len]
10.00 inch
254.0 mm
1.00 to 50.00 inch
25.4 to 1270.0 mm
Sets the maximum media length.
Settings Lock
Off
On
Off
Prevents a command changing the set value.
Keyboard Lock
Off
On
Off
Prevents a change by a key operation.
Note:
Hold down the Menu Key for at least 4
seconds to enter the Menu Setup Mode when
setting the "On" menu.
Control Code
STD
STD
ALT
ALT-2
Switches command mode of DMX mode.
Emulation Select
[Emulation Sel]
DM4
DM4
DMI
DPP
ZPI2
Selects DataMax®/Zebra® compatibility
DM4: DataMax® 400
DMI: DataMax® IClass
DPP: DataMax® Prodigy Plus®
ZPI2: Zebra® 2844Z
Emulation Auto
Detect
[Emulation Auto]
On
On
Off
Full Auto
Setting emulation (as above) auto detection.
After Print
AutoConfigure
[Auto Config]
On
On
Off
Automatically configures optional devices.
On.....AutoConfigure enabled (Regardless
of whether Function Select is set, if a
peeler or cutter is installed, each mode
is set automatically.)
Off
....AutoConfigure disabled (A peeler of
cutter is installed, but to not operate
the peeler or cutter, turn it Off and
the operation is selected by Function
Select.)
Function Select
[Function Sel]
Tear
Off
Tear
Peel On*
Cut On**
Selects the operation when the
AutoConfigure is set to Off. Designates the
paper position based on each option. The
operation of this device is enabled during
selection. At the same time, the parameters of
the f command of Prodigy Plus are emulated
for each optional device.
Cutter Type
Standard
Standard
Heavy Duty
Selects the cutter type.
Standard: Model JN98901
Heavy Duty: Model JN98911
Cutter Action
Backfeed
Backfeed
Through
Sets the cutter action.
With the optional AutoConfigure On, printing
is executed only when the cutter is installed
or only when Cut is selected by Function
Select.
Backfeed is always set after cutting.
Through is set at the rear end of sheets 1 to
n-1 when the number of copies = n, and the
rear end of the final page of single sheet and
copy is backfeed.
Peel Wait Delay**
0.1 sec
0.1 to 2.0 sec
Sets the Peel Wait Delay.
Displays only machines with a peeler
installed.
Paper Position
0.00 inch
0.00 mm
Peel/Cut/Tear Off
0.00 to 2.00 inch
0.0 to 50.8 mm
Peel/Cut/Tear On
-1.00 to 1.00 inch
-25.4 to 25.4 mm
Adjusts the stop position. It is based on the
inch/millimeter setting. There are initial values
of the stop position for each device set above,
and later, relative values are set.
Mode Settings
[Datamax® Emulation]
* Only when peeling option is mounted.
** Only when cutter is mounted.
