Citizen CL-E700 Series, Technical Manual

Page: 123 / 236

Chapter 3 Disassembly and Maintenance
3-6. Disassembly, Reassembly and Lubrication
3-
37 CL-E700 series
3-6-18. “Unit Head” and “Unit PF”
1. Remove the “Unit Ribbon”. Refer to “ 3-6-2 Unit Ribbon ”.
2. Remove the “Unit Opepane”. Refer to “3-6-10(1) Unit Opepane ”.
3. Remove the “Case” and “Cover Steel L”. Refer to “ 3-6-11 Case ”.
4. Remove all connectors from the “SA Main PCB”. Refer to “ 3-6-12(1) “SA Main PCB”
Connectors ”.
5. Remove the “Unit Mechanism”. Refer to “ 3-6-13 Unit Mechanism ”.
6. Remove the 1 screw (BH M3.0x4 (NI)) (

) and detach the earth wire of the “Unit Head” (

).
7. Open the “Unit Head” (

) and disengage the “Spring Head Up” (

).
8. Remove the 1 screw (BH M3.0x4 (NI)) (

), and detach the “Hook Head Up Spring 2” (

)
and “Spring2 Head Up” (

).
NOTE: At this time, hold the “Unit Head” (

) as it can fall off.
9. Disengage the 1 E-ring (E-Ring 4.0) (

), and then remove the 1 screw (NO2 PH (SW+PW)
M4.0x16 (NI)) (

) and “Shaft Head Holder” (

).
10. Remove the “Unit Head” (

) from the “Unit PF” (

).
Notes on reassembling:
• When assembling parts, apply FLOIL G-311S to the following places shown by the mark “

”.
A : Hole (front left). Circumference surface of the hole (on both sides) and inside the hole
B : Hole and projection (rear left). Circumference surface of the hole (on both sides) and
along the projection surface.
C : Along the contacting surface (rear left).
D : 3 surfaces on the “Shaft Head Holder” (

).
Hooks for “Spring Head Up” (

) and “Spring2 Head Up” (

) (4 places)
• When mounting the “Shaft Head Holder” (

), be sure that its mounting direction is correct.
D
FLOILG-311S
C
B
A
FLOILG-311S
FLOILG-311S
FLOILG-311S
FLOILG-311S
Shaft Head Holder
[Left side view]
BH M3.0x4 (NI)
Spring Head Up
Spring2 Head Up
BH M3.0x4 (NI)
Hook Head Up Spring 2
E-Ring 4.0
NO2 PH (SW+PW)
M4.0x16 (NI)
Unit PF
Unit Head
2
3
4
5
7
8
6
1
9
10