29
TS9000/TS9050 TouchStar Systems User Manual
Floppy Disk
If there is no floppy drive attached to the TouchStar, install
one using steps 1-4 of the previous procedure (Installing the
DOS Operating System). In step 3, instead of a bootable
disk, insert the disk containing the software application to
be loaded into the drive.
Downloading from the Network
When multiple copies of a software application must be
installed on a number of TouchStar units, copy the software
application from the server onto the Flash drive (C:\) of
each TouchStar using the DOS copy command.
Installing Windows 95
Windows 95 (CD) can be installed on the TouchStar’s ATA
drive. To do so, the ATA drive is first formatted and pre-
pared, then the software is installed from the CDROM as
described below. It is recommemded that the ATA drive be
configured as the Master C: drive (Please refer to the ATA
Socket Table 1 - Jumper JP-7.)
1. Connect the backpack floppy drive to the TouchStar’s
parallel port, and install the floppy drive in the setup
portion of the System Configuration Utility (SCU).
2. Set the Boot Device to BOOT DEVICES ONLY (WIN95),
and either enable or disable the Ethernet controller as
desired.
3. Format and prepare the TouchStar’s ATA drive using
CITADEL’s WIN95 ATA Drive Prep diskette. Once the drive
is prepared, disconnect the floppy drive and remove the
drive in the SCU.
4. Connect the backpack CDROM drive to the parallel port.
5. Boot the system from the ATA Drive (C:). The CDROM
drive should be visible as either Drive D: or E:.
6. Install the Windows 95 CD in the CDROM drive, and run
Setup. Windows 95 will prompt you for the remainder of
the installation. Note the TouchBase (T5) driver for Win-
dows 95 is available from CITADEL, and may be installed
after the Windows 95 installation is complete.
BASIC OPERATION - 3
