Check with your administrator to see if you need any certificates and arrange to install the certificates on your
phone.
Procedure
Step 1
Swipe up from the bottom of the phone’s display to show the installed applications.
Step 2
Tap the
Settings
app.
Step 3
Select
Network & internet
>
Wi-Fi
.
Step 4
Tap the desired Wi-Fi network name.
If the network doesn't have a security mode, the phone automatically connects to the Wi-Fi network.
If the network security mode is PSK, enter the 8–63 ASCII or 64 Hex Passphrase.
Step 5
For a network with a PEAP, EAP-TLS, or EAP-TTLS security mode, select the
EAP method
: PEAP, TLS,
or TTLS.
Step 6
For a network with an EAP-TLS security mode, select the desired
CA certificate
and
User certificate
.
Step 7
For a network with an EAP-TTLS or PEAP security mode, select the
Phase 2 authentication
method and
CA certificate
option to use, and then enter the
Identity
and
Password
.
Step 8
Tap
Connect
.
Add the Phone to a Nonbroadcast Wi-Fi Network
Follow these steps to add your phone to a Wi-Fi network that is hidden or not broadcast.
Before you begin
Get the following information about the Wi-Fi network from your administrator:
• Network name or Service Set Identifier (SSID)
• Network security mode:
• None
• Wi-Fi Protected Access II (WPA2)-Personal: Pre-shared key (PSK)
• WPA2-Enterprise with EAP method:
• Protected Extensible Authentication Protocol (PEAP)
• Extensible Authentication Protocol (EAP) Transport Layer Security (EAP-TLS)
• EAP Tunneled Transport Layer Security (EAP-TTLS)
• PIN or passkey for the security mode, if you use one
Check with your administrator to see if you need any certificates and arrange to install the certificates on your
phone.
Webex Wireless Phone 840 and 860 Administration Guide for Cisco Unified Communications Manager
59
Phone Configuration
Add the Phone to a Nonbroadcast Wi-Fi Network
