Step 6
Use your finger to press down until you feel and hear the battery clip snap into place.
Related Topics
, on page 33
Remove the Battery
Battery removal follows a reversed but similar procedure to battery insertion.
The steps to remove the battery are the same for both the Webex Wireless Phone 860 and Webex Wireless
Phone 840. However, the battery contacts are in different locations on these models. The illustrations in the
following steps are of the Webex Wireless Phone 860.
Procedure
Step 1
To disengage the battery clip, gently use a fingernail to depress the clip towards the top of the phone.
Don’t pull up on or twist the clip. Don't use a tool, such as letter opener or screwdriver, to pry the
clip open. An incorrect prying action with a tool can break the battery clip.
Caution
Step 2
Use your fingernail to lift the battery gently about an eighth of an inch (a few millimeters) out of the battery
compartment.
Step 3
Release the battery clip and grab the battery with your fingers.
Step 4
Use the battery tabs and battery compartment slots as a pivot point to raise the battery edge out the battery
compartment.
Don’t slide the battery across the battery compartment because this action may damage the contacts.
Warning
Webex Wireless Phone 840 and 860 Administration Guide for Cisco Unified Communications Manager
31
Initial Setup
Remove the Battery
