3-3
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
OL-16191-01
Chapter 3 Configuring with the Command-Line Interface
Configuring Fast Ethernet Interfaces
Verifying the Hostname and Password
To verify that you configured the correct hostname and password, follow these steps:
Step 1
Enter the
show config
command:
VG(config)#
show config
Using 1888 out of 126968 bytes
!
version XX.X
.
.
.
!
hostname VG204
!
enable secret 5 $1$60L4$X2JYOwoDc0.kqa1loO/w8/
.
.
.
Check the hostname and encrypted password displayed near the top of the command output.
Step 2
Exit global configuration mode and attempt to reenter it, using the new enable password:
VG#
exit
.
.
.
VG con0 is now available
Press
RETURN
to get started.
VG>
enable
Password:
guessme
VG#
Tip
If you are having trouble, ensure the following:
•
Caps Lock is off.
•
You entered the correct passwords. Passwords are case sensitive.
Configuring Fast Ethernet Interfaces
To configure a Fast Ethernet interface, use the configuration software provided with your Cisco VG.
Otherwise, for greatest power and flexibility, use configuration mode (manual configuration).
This section describes basic Fast Ethernet interface configuration, including enabling the interface and
specifying IP routing. Depending on your own requirements and the protocols you plan to route, you
might also need to enter other configuration commands.
Before you begin configuring the interfaces, make sure to do the following:
•
Connect a console to the Cisco VG.
